Problema comun
F.A.Q
FAQ
Broken tail pull and shell rupture
the installation dimension does not match the use environment → hard pull (the minimum installation dimension of the environment is greater than the minimum installation dimension of the push rod) → hardtop (the maximum installation dimension of the environment is less than the maximum installation dimension of the push rod)
FAQ
The push rod shakes or slides when it reaches the top
1. the self-locking force of the push rod is insufficient 2. Unreasonable configuration and selection 3. Exceeding the rated load of push rod 4. No electronic short-circuit self-locking function
FAQ
Abnormal quick release push rod
The motor rotates but cannot rise → the cable is too tight, causing the clutch sleeve to disengage → the clutch sleeve is damaged
FAQ
One of the push rods does not work
The relay has the sound of closing → check whether the motor plug is inserted in place → no-load test of the push rod → replace the push rod plug control → check the push rod → check the controller
FAQ
if it is caused by the periphery → check whether the key gasket of the manual controller is stuck → check whether the key is too high against the panel → check whether the manual controller wire is damaged or short circuited → check whether the solder joint of the manual controller plug and adapter wire plug is short circuited with tin → check whether the pin of the manual controller is bent or short circuited → check whether the manual controller key is mechanically damaged or suffocated
FAQ
The manual controller displays an error → power off and power on for retest → enter the system into reset test → check whether the corresponding control line plug is inserted in place (E07 M1 control is abnormal, E08 M2 control is abnormal) → check whether the adapter line is connected in place → replace the push rod plug control → check the corresponding control push rod → check the controller
FAQ
No response or action of operation keys
If the push rod itself makes abnormal noise → the movement electromagnetic sound is loud → the bearing sound is loud → the worm and bevel gear are not meshed well → the external force strikes the motor to cause abnormal sound → the torsion spring makes abnormal noise → knocking and wiping the pipe
FAQ
WHY DO YOU CHOOSE THE STANDING DESK?
With the development of science and technology, we will work in the office for a long time. Although the current office chair is designed according to the ergonomic chair, sitting in the office for a long time will still make people feel back pain. In order to change this state, the most direct way is to use the adjustable standing desk to realize the standing office. Sitting office posture is not correct, it is easy to cause a variety of cervical and lumbar problems. Standing office helps to tighten muscles and reduce the occurrence of scapulohumeral periarthritis and spondylosis. Sit and stand alternately to create a healthier way of working.
FAQ
KINGAUT Linear Motion Technology Co.,Ltd.1
KINGAUT Linear Motion Technology Co.,Ltd. was founded in 2006, has become a professional lineardrive product development, production and sales of high-tech enterprises after more than ten years of development.
FAQ
KINGAUT Linear Motion Technology Co.,Ltd.
KINGAUT Linear Motion Technology Co.,Ltd. was founded in 2006, has become a professional lineardrive product development, production and sales of high-tech enterprises after more than ten years of development.
